Panel Lock
Press the pad, the emply space between
“warm” and “light” pads, then the pad within 3
seconds. When locked, the display will show the
temperature you have chosen along with the “lock”
symbol. To unlock, press the pad, the empty
space between “warm” and “light” pads, then the
pad within 2 seconds. The lock symbol will
disappear and all panel pads will work again.
On hot tubs with turbo option: Press,
within 3 seconds. When locked, the display
will show the temperature you have chosen along
with the “lock” symbol. To unlock, press the
pads within 2 seconds. The lock
symbolw ill disappear and all panel pads will work
again.
Temperature Lock
Press or then press the the empty
space between “warm” and “light” pads, then the
pad within 3 seconds. when locked, the
display will show the temperature you have chosen
along with the “lock” symbol if or
is pressed. To unlock, press the pad, the
empty space between “warm and light” pads, then
the pad within 2 seconds. The lock symbol
will disappear and all panel pads will work again.
On hot tubs with turbo option: Press or
then the pad within 3 seconds.
When locked, the display will show the temperature
you have chosen along with the “lock” symbol. To
unlock, press the pads within 2
seconds. the lock symbol will disappear and all
panel pads will work again.
Standby Mode
Press or then within 3 seconds to
prevent the hot tub from operating at any time.
Standby mode should be used when replacing the
filter. All hot tub functions will be disabled except for
freeze control. Press any button to resume spa
operation.
DISPLAY MESSAGES
DISPLAY FLASHES “OH”.
“Overheat” - The hot tub has shut down. Either the
water has reached 112
o
F./44
o
C, or the high limit
sensor has detected 118˚ F/48
o
C at the heater.
DO NOT ENTER THE WATER. Remove the hot tub
cover and allow water to cool. At 110˚F/43
o
C, the hot
tub should automatically reset. If the hot tub does
not reset, then turn off all power to the hot tub and
contact your dealer or service organization.
DISPLAY FLASHES “FLO”.
“Flow” (Flashing) - Flow of water is inhibited.
Check and open flow valves. Check for correct
water level. Clean filter.
DISPLAY FLASHES “FLO”.
“Flow” (Not flashing) - A pressure switch has
manfunctioned.
Contact dealer or service organization.
DISPLAY FLASHES “COOL”.
“Cool” - Water temperature is more than 20
o
F/7
o
C
below the temperature you last set.
No action required. Spa is functioning properly.
DISPLAY FLASHES “ICE”.
“Ice” - Potential freeze condition is detected.
No action required. Pump(s) will automatically
activate regardless of hot tub’s status.
DISPLAY FLASHES “Sn1”.
“Sensor1” - Hot tub is shut down. Hi-limit sensor is
not working.
Contact your dealer or service organization.
DISPLAY FLASHES “Sn3”.
“Sensor 3” - Hot tub is shut down. Water
temperature sensor is not working.
Contact your dealer or service organization.
DISPLAY FLASHES “Stby”
“Standby” - Hot tub is in standby mode. All hot tub
functions are disabled except for freeze control.
Press any button to resume operation.
WARNING! SHOCK HAZARD! NO USER
SERVICEABLE PARTS.
Do not attempt service of this control. Contact your
dealer or service organization for assistance. Follow
all owner's manual power connection instructions.
Installation must be performed by a certified
electrician and all grounding connections must be
properly installed.
Programmable Control Instructions/Digital 3000 5 - 2