Free Craft Pattern from Lion Brand Yarn
Lion Brand
®
Vanna's Glamour
TM
Temari Ball Ornaments
Pattern Number: L0117AD
SKILL LEVEL: Intermediate
SIZE: One Size
Set of 3
Finished Circumference About 10 in. (25.5 cm)
CORRECTIONS: None as of Sep 14, 2010. To check for later updates, click here.
MATERIALS
• 861-150 Lion Brand Vanna's Glamour: Platinum
1 Ball (A)
• 861-149 Lion Brand Vanna's Glamour Yarn: Moonstone
1 Ball (B)
• 861-171 Lion Brand Vanna's Glamour Yarn: Gold
1 Ball (C)
• 861-186 Lion Brand Vanna's Glamour Yarn: Bronze
1 Ball (D)
• 861-170 Lion Brand Vanna's Glamour: Topaz
1 Ball (E)
• Large-Eye Blunt Needles (Set of 6)
• Additional Materials
3 craft foam balls, each about 10 in. (25.5 cm) circumference
T-pins
Craft glue
GAUGE:
Exact gauge is not important to this project
NOTES:
1. Be sure to read through General Instructions and review the diagrams before beginning. A Temari Ball is
not difficult to make, but does require careful handling of the yarn to create a tidy design.
2. Materials are sufficient to make one of each Temari Ball in set.
GENERAL INSTRUCTIONS
1. Each foam ball is first wrapped with a foundation wrap. Hold one end of specified yarn on a foam ball. Wrap yarn over entire ball,
taking yarn in different directions as when winding a ball of yarn. When ball is completely wrapped with yarn, secure end of yarn with a
drop of glue. Allow glue to dry, then trim yarn end.
2. With T-pins, mark 2 points, directly opposite each other, for North and South Poles.
3. Wrap a strand of yarn around ball from pole to pole, dividing ball in half, then from pole to
pole once more to divide ball into quarters.
With another strand of yarn, wrap the ball at the equator, thus dividing ball into eight
sections. The strands will cross at each pole and at
4 points around equator for a total of 6 points where the strands cross (Diagram 1). Glue ends of each strand in place. When glue is dry,
trim yarn ends. Note that the strands applied in this step have crossed at specific points. These crossed points will be used in creating
additional designs on the ball. To create the shapes on the Square Eye and Hexagon balls, yarn is woven around the strands at each
cross point. To weave yarn, thread yarn into blunt needle. Insert threaded needle under foundation wraps to hide end of yarn. Draw
threaded needle over and around each of the crossed strands to weave (Diagram 2). Working in a clockwise direction, weave around the
crossed strands in a spiral for the number of times specified in the pattern.